Leeson Chassis Mount PWM Control: 175292.00 Manual do Utilizador descarregar pdf (Página 11)

Installation

Use 18 AWG wire for speed adjust potentiometer wiring.

• Size the DC voltage input and motor wire according to the

following chart:

Table 1. Wire Gauge/Length Chart

Armature Current Wire Gauge Maximum Wire

(amps) (AWG) Length (feet)

0 – 19 14 8

20 – 32 10 10

60 8 10

Wiring

Warning

Do not install, remove, or rewire this equipment with power

applied. Failure to heed this warning may result in fire,

explosion, or serious injury.

This drive is isolated from earth ground. To prevent the

risk of injury or fatality, avoid direct contact with the printed

circuit board or with circuit elements.

Do not disconnect any of the motor leads from the drive

unless power is removed. Opening any one motor lead

may destroy the drive.

This drive is not diode-protected from reverse battery

voltage. You must assure that POS (+) is wired to +VDC

IN and NEG (–) is wired to –VDC IN.





1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Sem comentários

Leeson Chassis Mount PWM Control: 175292.00 Manual do Utilizador Página 11